Vitek VTC-C770DNIP2 Manuel d'utilisateur télécharger pdf (Page 8)

ENVI Series IP Configuration Manual

________________________________________________________________________________

2. Installation

1. Connecting Network (LAN)

 Connect a LAN Cable to LAN port of HTP-T13MG.

2. Connecting Serial Ports

The RS-485 of the ENVI IP2 Camera can be connected to external equipment such as PT receiver etc.

PC client can send PT commands to the external equipment via the serial port.

When a decoder system, instead of a PC client, is connected to the ENVI IP2 Camera, the serial port

and that of the decoder system works in pass-through mode. That is, data from one port is delivered to

the other port, and vice versa.

3. Connecting Sensor and Alarm

Connect sensor and alarm devices to corresponding terminals accordingly.

4. Connecting Power

After confirming the power source, connect power adaptor and connect the 12VDC connector to the

system.

5. Does it Work?

Once the power is supplied to the camera, it will start booting. The system will boot up to an operating

mode after approximately 40-60 seconds. The green LED on the Ethernet port will flash indicating the

system is ready.

The software provided on the disc called ENVI VMS allows you to check the IP address and other

network details of the camera.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Pas de commentaire

Vitek VTC-C770DNIP2 Manuel d'utilisateur Page 8