Vitek VTC-C960WS Spécifications télécharger pdf (Page 19)

OSD MENU FEATURES/SETUP

1-6-2. DAY :

1-6-3. NIGHT :

• Verify ‘DAY/NIGHT’ after completing all settings of lens for zoom and focus.

• If the gap between DAY->NIGHT and NIGHT->DAY is too small, camera may repeat

switching DAY from/to NIGHT. If NIGHT->DAY is decreased from the Factory default,

the same amount is recommended for DAY->NIGHT to avoid repeating

DAY<->NIGHT unintentionally.

CAUTION

DAY->NIGHT and NIGHT->DAY operations must be examined and verified at

the final installation.

Block the lens for a few seconds for NIGHT mode and release and let it return to

DAY mode. If camera stays at NIGHT mode more than 10sec, decrease NIGHT->

DAY THRESHOLD a little and repeat the fore-mentioned steps. If the scene

is too dim or lens iris was

adjusted too low(near close), it may not return to DAY.

IMPORTANT ACTIVITY

• BURST (default: OFF) :

NIGHT→DAY is a threshold level which determines to switch from NIGHT to DAY.

Lower(Higher) value makes the camera switch from Night to Day at lower

(higher) illumination. If it stays in Night(B/W) mode in day time, decrease NIGHT->

DAY threshold value until it just switches to Day

* Examine and verify Day/Night operation according to IMPORTANT ACTIVITY

• NIGHT -> DAY (default: 120)

Sets the BURST option ON/OFF to output burst signal in B/W mode.

The camera is always in B/W mode.

The camera is always in Color mode.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 37 38

Pas de commentaire

Vitek VTC-C960WS Spécifications Page 19