Vitek VTC-IRE40 Spécifications télécharger pdf (Page 20)

6.14 CAMERA ID menu

Up to 40 characters can be used/input for camera ID.

To enter CAMERA ID menu, press ● button in MAIN menu-2>CAMERA ID.

Use ▲,▼,◀,▶ buttons to move a block cursor over the character table and press ● button to input the

selected character.

To move the character input position on CAMERA ID input line, move a cursor to ←→ on COMMAND LINE

and press ● button on ← or → .

To clear CAMERA ID input line, move a cursor to CLR on COMMAND LINE and press ● button.

To set the location of CAM TITLE to be displayed on the monitor, move a cursor to POS and press ● button

and then menu disappears and CAMERA ID will be displayed on the monitor.

Move CAMERA ID by using ▲,▼,◀,▶ buttons and press ● button to fix.

Menu will appear again. To finish CAM TITLE menu, press ● button on RET on command line.

6.15 CAMERA RESET

Camera loads Factory defaults.

To save them, go to SAVE ALL and press ● button.

6.16 EXIT

Exits SETUP MENU and returns to the normal display

COMMAND LINE

CAMERA ID input line

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Vitek VTC-IRE40 Spécifications Page 20