Vitek VT-3496 Guide de l'utilisateur télécharger pdf (Page 42)

VT-HDOC Series

 F/W VERSION: Shows the firmware version of the HYBRID-DVR.

 H/W VERSION: Shows the hardware version of the HYBRID-DVR.

 UI VERSION : Shows the UI version of the HYBRID-DVR

 VIDEO SIGNAL TYPE: The HYBRID-DVR can be selected between PAL and NTSC via a

selector

 HDD NUMBER: Shows the hard drive capacity installed.

 IP ADDRESS 1(Ethernet Port): Shows either the manual IP address entered in NETWORK

setup or the IP address assigned by a DHCP server if enabled.

 IP ADDRESS 2(Local Port): Shows either the manual IP address entered in NETWORK

setup or the IP address assigned by a DHCP server if enabled.

 MAC address 1(Ethernet port): show mac address configured by manufacturer.

 DDNS SERVERADDRESS: If DDNS is enabled, the host DDNS server is specified here.

 HYBRID-DVR SERVICE PORT: port number for HYBRID-DVR network operation

 WEB SERVER PORT: The port number that the HYBRID-DVR uses to support remote

connections.

 FAN STATUS: Displays FAN Speed of HYBRID-DVR (RPM).

If cooling fan’s speed is lower than certain level, an alarm will occur.

 TEMPERATURE: Display internal temperature of HYBRID-DVR (℃/℉).

SYSTEM NAME: A system name of up to 15 characters can be defined. It is used so that

notification emails can be identified.

F/W UPGRADE: Firmware updates may be released periodically to enhance system

performance and add extra features. The operator can upgrade the firmware using a USB

memory stick.

FACTORY DEFAULT: If settings have been changed which causes erratic behavior, the

factory default settings can be loaded.

SYSTEM DATA: System settings can be saved to a USB memory stick. The settings can

be reloaded in case of accidental factory reset or can be transferred to another HYBRID-

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 95 96

Pas de commentaire

Vitek VT-3496 Guide de l'utilisateur Page 42